Hello I had a question about your Evo softail I know yours is a few years older than mine but it should be quite close possibly the same what is the eye to eye measurement of the shift linkage. I ask because I think mine has been altered the arm that goes down to the transmission Has not been touched. But I think the rod lingth has been altered if you get a chance could you measure yours hole to hole
Thank you 😀

When I get a chance I’ll study all u wrote
Thank you

Tom this would be a good price with free shipping. You would need to use your Bolt and charging handle and still need to get Iron sights . So while the $349 looks like a lot more it really a better deal

Example. This is a Stainless Steel 18 inch Wylde chambered 223/5.56 1 in 7 twist. with 15inch free float rail key mod. And MAGPUL flip up iron sights . Come with Bolt carrier group and charging handle. Pop two pins take your off out new one on snap pins , go shoot.

This would be considered a big upgrade fro what you have

http://palmettostatearmory.com/psa-1...t=5%3a00+Email

Tom , on your AR couple ways to go if you want a flat top. Really easy way and one that would require some work. You would need to decide , do you want to stay with an A2 type front sight( I recommend no) or go with a good free float rail and use flip up iron sights, plus have the flexibility to install any sight or scope you want with ease.
Best way and easiest :
Purchase a complete Upper from PAS with the rail you want. it is a 2 minute swap out your upper stays as is. Cost is not bad and if you are ready to buy when the deal is right you can get some great deals.

Second option is to use all of your parts except the upper receiver. About hale the cost but a lot of work if you are no use to doing it . Also always a chance of damaging the A2 front sight when removing it. Down side you still have a A2 front sight and simple hand guards no rail. Another down side is once you figure out you really want a good rail on it will cost you more than it would to have done it the easy way.

I’m pretty lucky I have a couple handguns the only way I would buy the neighbors Beretta is if it was a great price. Neighbor’s been working all week downstate he’s a roofer have not heard anything about the gun lately. Let me know how I would check my upper to see if it would be compatible thank you

If you are looking for a good affordable CC 9mm let me know I will give you some ones to look into . No one weapon is right for everyone. There are some very affordable ones that do not make the latest and greats internet forums.
Nothing wrong with setting a budget listing what you need it to do for you and shopping for the right one.

That’s what my neighbor was saying he goes this is just too big to carry concealed but I spoke to him yesterday and he did not mention selling the gun anymore so it may have just been. Checking to see what I would pay for anyone else

15 round and says 92FS on the slide then value on first post applies. The last year has seen a leveling off , market correction on use gun values. The last 92FS I purchased New was $560 that was some years back. On a good sale.
92FS is a larger 9mm hard for CC for some. It is an outstanding firearm

Is is the 15 round Baretta I checked